Ghostbusters 2 Spirit Halloween Rubies ghost trap upgrade kit

Ghostbusters Trap Resistor, GB 2 Aluminium Knob, Shaft, Side Plate Screws, Hose Connector, Raytheon Knob, shaft inner plate Replacement toggle switch

Ghostbusters 2 style aluminium knob comes with shaft enabling the knob to actually turn. Big improvement on the moulded plastic ones of the Spirit Halloween / Rubies traps. Just hacksaw the moulded one off screw on the plate over it as I have in photos. All holes in plate pre drilled for you. You just need to drill a 7mm hole through the trap wall to push the knob shaft through. For the resistor I just milled sanded the moulded one down this new one fits perfectly over where the original one was. Resistors are old stock so serial numbers on them may vary. Supplied with 6 screws to attach the resistor plate but would still recommend some glue on the back of them as it is only thin plastic the screws are more for show. 3d printed side skirted Raytheon knob. Again, I just hacksawed the moulded plastic one off. Plate included to glue inside with pre drilled hole to put shaft through for the raytheon knob. You just need to drill a 7mm hole in the rear of the knob then hot glue it onto the shaft. For the more realistic metal toggle switch you just need to clip the wires off the plastic one on the Spirit / Rubies trap drill a 12mm hole to accommodate the new toggle switch. For the hose connector its just a case of drilling a 12mm hole again screwing in which is a nice tight fit. Kit with Ghostbusters 1 style knob also available on other listing. Also great for custom builds. Any questions then please ask 🙂